Under the lattice work station

Countertop: inside is a 1 inch (25 mm) composite board with high pressure HPL.

The edge of the table is formed by casting flexible polyurethane on the outside, with a width of no less than 30mm.

Unit front :(18mm solid wood particleboard is used internally), high pressure HPL is used on the surface, and hinges must be used to simplify installation.

Width of working face: 450mm-800mm;

The distance from the surface to the ground is 720-750mm, and the bottom adjusting foot can be fine-tuned;

Working face support arm: material strength standard no less than no. 10 cold-rolled steel; The strength of the reinforcement shall not be lower than that of no. 12 cold-rolled steel.

Bottom support: bending stress not less than 110 KSI.

HPL cover: rated thickness: not less than 1.2mm; Thickness error: ±0.12mm or less (including quantity); Wear resistance: no less than 400 cycles.

Upgrade monitor station technical requirements

Most of the main structures of the lifting stations are the same as those of ordinary stations.

The electric lift control structure is used to monitor the main parts of the operator (desktop, keyboard control, display rack).

Technical parameters: the frame structure of the monitoring platform is made of 10Gauge (3.429mm) cold-rolled steel plate, which is pressed and formed by CNC machine to form the structure frame. These structural frames are tensioned to form a polished rectangular structure.

Main support is made of 10Gauge (3.429mm) cold-rolled sheet. The auxiliary frame is made of 12Gauge (2.667mm) cold-rolled sheets.

Manufacturing error control is linear ± 0.5mm; Vertical + / - 0.5 °

The main frame structure is also composed of the same module design principles as ordinary workstations, and combined with the corners;